300mm Male-Male Servo Lead

The ShockWave 3 module includes one of these lead as well as one male-male-female custom Y servo lead. If you want to use more than one RC sound select inputs on the module you will need to purchase more of these cables.

What's New:

April 25, 2022

New Serial Bus Feature supports Spektrum SMART ESCs, Graupner SUMD, Futaba S.Bus and many more. Greatly simplifies wiring with a compatible Serial Bus Receiver.

February 15, 2022

New Learjet 35-70 executive jet sound set added bringing our total airplane sound sets
to 123.

November 06, 2021

New Shelley Foss Tugboat sound set added bringing our total boat sound sets to 75.

September 27, 2021

New RNL Tamar Class lifeboat sound set added bringing our total boat sound sets to 74.

September 05, 2021

Many Battleship/Warship sound sets added bringing our total boat sound sets to 73.

300mm Male-Male Servo Lead

Name : Male-Male servo lead - 300mm (12in) long

Length : 300mm
Weight : 6.2 grams - 0.22oz

USD$1.29

This male-male servo leadis 300mm long and uses 22AWG stranded wire. It is used to connect one of your RC receiver auxilliary channel outputs to one of the Sound Select inputs on the ShockWave 3 sound module and is typically used to control sounds such as weapons fire, bells, horns, music, voice announcements etc. The ShockWave 3 sound module includes one of these cables for one Sound Select Input and one male-male-female Y servo lead for throttle/ESC connections.

If you want to use additional Sound Select inputs you will need an additional one of these cables per input.

Note: These are called male-male servo leads to comply with the usual naming conventions used in the RC industry. This convention refers to the gender of the connector shell. However, in the electronics industry, the convention is to refer to the gender of the connector pins themselves, in which case these are female-female cables.