--> Downloads - Model Sounds Inc. - The Ultimate in RC Sound Systems

Downloads

Here, you can find the latest firmware and software releases, and release notes. Upgrading your ShockWave 3 sound module to enjoy the latest features is easy and fast.

What's New:

April 25, 2022

New Serial Bus Feature supports Spektrum SMART ESCs, Graupner SUMD, Futaba S.Bus and many more. Greatly simplifies wiring with a compatible Serial Bus Receiver.

February 15, 2022

New Learjet 35-70 executive jet sound set added bringing our total airplane sound sets
to 123.

November 06, 2021

New Shelley Foss Tugboat sound set added bringing our total boat sound sets to 75.

September 27, 2021

New RNL Tamar Class lifeboat sound set added bringing our total boat sound sets to 74.

September 05, 2021

Many Battleship/Warship sound sets added bringing our total boat sound sets to 73.

ShockWave 3 Downloads

Downloading From This Page

You should be able to simply click on the links below to save them to your hard drive.
If that does not work, or if your web browser attempts to open them, right click on the link and select "Save target as ...". This will open a Dialogue box asking you where you want to save the file.

ShockWave 3 Firmware is for use ONLY with ShockWave 3 sound modules.

Note: Each firmware release on the ShockWave 3 module MUST be used with the same ShockWave 3 PC Software release on the PC.

CAUTION: Firmware releases of 5.1.2 and later are for use ONLY with our latest Revision 10 ShockWave 3 boards. These boards were shipped after November 25, 2021.

The last firmware release for older Revision 8 and Revision 7 boards is 5.1.1, see below.

  1. All Release Notes

    ShockWave 3 Sound Module Release Notes


  2. For all Releases

    ShockWave 3 Firmware Version Checker Installer ZIP File


  3. Current Production Release 5.1.3 (for Revision 10 boards only)

    Firmware 5.1.3 .hex (ZIP) File for ShockWave 3 sound module.

    Also included in the ZIP file is the new enhanced BasicHardwareSettings.txt file, to be copied to the microSD card. This file is required to support the new Serial Bus feature in release 5.1.3.


  4. Previous Production Release 5.1.2a (for Revision 10 boards only)

    Firmware 5.1.2a .hex (ZIP) File for ShockWave 3 sound module.


  5. Prior Production Release 5.1.2 (for Revision 10 boards only)

    Firmware 5.1.2 .hex (ZIP) File for ShockWave 3 sound module.


  6. Earlier Production Release 5.1.1 (for Revision 8 or 7 boards)

    Firmware 5.1.1 .hex (ZIP) File for ShockWave 3 sound module.


Click here for instructions for upgrading your ShockWave 3 firmware using the microSD card Bootloader.


Click here for the excellent free Audacity sound editor.