4inch (100mm) Loudspeaker
This loudspeaker is especially well suited for use in RC Models, especially RC airplanes and helicopters due to its very high sensitivity. It has been carefully chosen for the best balance between sensitivity, power handling, weight and frequency response.
What's New:
February 15, 2022
New Learjet 35-70 executive jet sound set added bringing our total airplane sound sets
to 123.
November 06, 2021
New Shelley Foss Tugboat sound set added bringing our total boat sound sets to 75.
September 27, 2021
New RNL Tamar Class lifeboat sound set added bringing our total boat sound sets to 74.
September 05, 2021
Many Battleship/Warship sound sets added bringing our total boat sound sets to 73.
4inch (100mm) Loudspeaker
![]() |
Name : 4inch 20 Watt 4 Ohm loudspeaker
USD$22.99
ONLY Canadian and US Customers |
Highly recommended for model airplanes and helicopters - This German engineered loudspeaker sounds terrific, yet is shallow and weighs only 162grams. This fine loudspeaker can handle 20 Watts continuous, 30 Watts peak.
This 4 Ohm speaker can be used with our ShockWave series sound modules with
no more than a 4S LiPo battery. If you wire two of these in series, the sound module
can be powered on its maximum battery voltage of a 6S LiPo for maximum sound output.
Our loudspeakers can be ordered by new customers only at the same time as ordering a sound module from us, or by existing customers later who have already purchased a sound module from us. When two of these speakers are used in series, the output level from our ShockWave series sound modules (on 26 Volts) can be around 107dB. This was measured with the speakers in open air. When housed in a small enclosure, the sound level will be even higher. |

