300mm Male-Male-Female Servo Lead

The ShockWave 3 module includes one of these Y leads as well as one male-male servo lead. This custom Y lead is used to connect both your ESC and the ShockWave 3 module to your radio receiver. If you want to use more than one Throttle RC input on the module you will need to purchase one more of these cables.

What's New:

September 27, 2021

New RNL Tamar Class lifeboat sound set added bringing our total boat sound sets to 74.

September 05, 2021

Many Battleship/Warship sound sets added bringing our total boat sound sets to 73.

May 14, 2021

New Hercules AC130 gunship sound set now available bringing our total airplane sound sets to 120.

February 17, 2021

New Airbus A380 sound set now available bringing our total airplane sound sets to 119.

January 26, 2021

New 5.1.1 release of ShockWave 3 firmware and Software. Exciting new features - Afterburner light controller + automatic sync. with Afterburner sound and much more.

300mm Male-Male-Female Servo Lead

Name : Male-Male-Female Y servo lead - 300mm (12in) long

Length : 300mm
Weight : 9.0 grams - 0.33oz

USD$1.99

This male-male-female custom Y servo lead with is 300mm long and uses 22AWG stranded wire. It is used to connect the RC receiver throttle output to both our ShockWave 3 sound module and your ESC. The ShockWave 3 sound module includes one of these cables and one male-male servo lead for one Sound Select Input to control weapons fire or bells/horns etc. sounds. This is the usual configuration.

If you want to use both throttle inputs you will need an additional one of these cables.

Note: These are called male-male-female servo leads to comply with the usual naming conventions used in the RC industry. This convention refers to the gender of the connector shell.
However, in the electronics industry, the convention is to refer to the gender of the connector pins themselves, in which case these are female-female-male cables.